EASY 5 STEP INSTALLATION
FOR FIBERGLASS HULLS
1.
Verify that the hull thickness does not
exceed 3” or 80mm then select the location choice on your boat
approximately 12”
or 250mm below the water line. Drill using a pilot bit first to
ensure there are no internal obstacles.
2.
Loosen the cable connector at the rear
of the cap, then remove the rear cap counter clockwise and place
light and cap in a safe place until fixture is installed. Using a
holesaw, cut out a 4.50” or 115mm diameter hole.
3.
Clean hole thoroughly using 3M adhesive
remover or a similar alcohol-based agent. Be sure to seal the core,
if needed, with marine epoxy or 3M 5200.
4.
Install the fixture using 3M 5200 or
4200 Fast Cure Silicon, just as you would with any other thru hull,
then hand tighten internal locking ring. Once the ring has been
tightened, lock the 4 locking bolts firmly against the hull. Next
clean all excess 5200 from the surrounding area with 3M adhesive
remover or a similar alcohol-based substance.
5.
Re-connect cable connector, then hand
tighten cap clockwise. Be sure to leave sufficient cable length for
bulb changes and service ( + 2-3 feet). Connect bonding
strap.
IMPORTANT NOTES
INSTALLATION: All installations
including electrical should be performed by qualified personnel
only. The manufacturers and dealers of Xtreme Beam will not be held
responsible for improper installations. Refer to electrical diagram
on ballast.
PRODUCT GUARANTEE: The Xtreme
Beam Fixture is guaranteed for 1 year from purchase date. This
guarantee does not include removal, installation or lamp life. Proof
of purchase is required.
ALUMINUM HULLS: Do not use
stainless fixtures for aluminum hull vessels; only aluminum fixtures
should be used. Prep and paint aluminum fixtures as you would the
rest of the hull. Refer to boat builder for more information.
LENS: The lens has been
installed and tested by Advanced Marine Underwater Lighting and
should not be tampered with in any way.
View
Specs
Answers To Frequently Asked Questions |
