|
EASY 5 STEP
INSTALLATION FOR FIBERGLASS HULLS SMX-2
1.) Verify that the
hull thickness does not exceed 3or 80mm, then select the location
choice on your boat approximately 12or 250mm below the water line.
Drill using a pilot bit first to ensure there are no internal
obstacles.
2) Disconnect the connector. Using a holesaw drill a 3.5 Diameter
hole.
3) Clean hole thoroughly using 3M adhesive remover or similar
alcohol based agent. Be sure to seal the core, if needed, with
marine epoxy or 3M 5200 silicone.
4) Install the fixture using 3M 5200 or 3M 4200 Fast Cure Silicone,
just as you would with any other thru hull fitting. Then hand
tighten the internal locking ring. Once tightened, lock the 4
locking bolts firmly against the hull. Do not over tighten; be sure
to leave a sufficient bead of silicone around the fixture.
5) Now clean all excess silicone from the surrounding area with 3M
adhesive remover or similar substance. Reconnect the connector. Be
sure to leave sufficient cable length for easy bulb changes and
service. Connect bonding strap.
Important notes:
Keep unit clear of all
obstructions.
Do not rest anything against the light. Installation:
All installations including electrical should be performed by
qualified personnel only. The manufacturers and dealers of Xtreme
beam and its related products will not be held responsible for
improper installations. The LENS has been installed and tested by
Advanced Marine Underwater Lighting and should not be tampered with
in any way.
PRODUCT GUARANTEE: The SMX-2
body and lens only is guaranteed for 2 years from date of purchase.
The guarantee does not include removal or installation of the light.
The ballast and electrical components are guaranteed for 1 year from
date of purchase. The lamp is guaranteed for 30 days. Proof of
purchase is required for all guarantees.
ALUMINUM HULLS: Do not use stainless fixtures for
aluminum hull vessels; only aluminum fixtures should be used. Prep
and paint aluminum fixtures as you would the rest of the hull. Refer
to boat builder for more information.
LENS: The lens
has been installed and tested by Advanced Marine Underwater Lighting
and should not be tampered with in any way.
View
Specs /
View DC Electrical Diagrams /
View AC Electrical
Diagrams
Answers To Frequently Asked Questions |
